How to improve Favorite loading time.
​
Each time you power up the Scanner it loads the data from the card ready for use.
​
In some cases this can take between a few seconds to a minute depending on the amount of data.
​
Just like a computer the Scanner has to read all the installed data and prepare itself for operation.
​
To avoid this delay - you can turn off the Favorites that are not being used in your area - saving your Scanner time when ‘booting up’.
​
This process does not delete or remove any Favorite.
​
Turn the Scanner on and let it load all the data off the card as it normally would.
​
One all the data is loaded and the Scanner is operational, push the MENU pad/button.
​
Set Scan Selection will be highlighted.
​
Push the E.yes button.
​
Manage Quick Key Status will be highlighted.
​
Scroll down the Menu and highlight Select Lists to Monitor
​
Push the E.yes button.
​
Full Database will be highlighted.
​
AUSTRALIAN USERS - Full Database and Search with Scan should both be OFF by default. Leave them OFF!
Scroll down the list and highlight your choices that are not relevant to your current location - selecting the correct ones to turn OFF will improve the ‘Boot up’ time of the Scanner.
If your data card contains locations that are geographically too far away to monitor - turn them off.
​
Highlight the Favorite that you wish to turn OFF. Then push the E.yes button.
​
This will change the tag from ON to OFF.
​
Make as many selections as you like from the Menu listing.
​
Once you have selected all the Favorites that you do not require, push the System or the Scan button - depending on your model.
​
The Scanner will remember your selection and when you power up again it will only load the Favorites you have marked as YES.
​
If you travel to a new location you can repeat the process again and turn ON any Favorites that were turned OFF previously